![]() ![]() There should be no more than 1/8” sticking out. With a set of wire cutters, take off the top of the plug. Allow the substance to harden for about five minutes. Wipe off any tire sealing cement from the plug area with a paper towel. If all looks well, you can fill it up the rest of the way. Use your soapy water once again to look for leaks. You won’t want to fill it to maximum capacity until you realize there is no leak. Hook up the air compressor and fill up the tire. This should remove the plug from the tool, where it stays in the tire. With an inch of the strip sticking out from the surface of the tire, pull the handle of your tool straight up. You may need to use a little pressure to get the job done. Push the insertion tool into the hole with the cement-slathered plug attached. Use this sealant in the tire’s hole as well. You can use a pair of pliers to get it pulled through.Ĭoat the plug in the tire sealing cement that comes with the kit. Put it into the eyelet of the insertion tool. If the hole is too small to get the tool inside, you can use a smaller drill bit to get started. This creates more space for the plug to seal. Move it up and down a few times as you rotate it. Stick the T-handle tool from the kit into the hole. With a set of pliers, you can remove the object that caused the puncture. Spray the solution over the tire until you see bubbles coming out of the leak location. Otherwise, fill up a spray bottle with 80 percent water and 20 percent dish soap. Sometimes, it’s not hard to find, especially if there is a screw or nail in the rubber. You don’t need to take the tire off of the rim to plug the hole. READ MORE: How Much Does It Cost To Get a Tire Patched? How to Plug a Car Tire 1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |